Difference between revisions of "Calibration Device for Scintillators"
Jump to navigation
Jump to search
| Line 11: | Line 11: | ||
== Belt System == | == Belt System == | ||
| − | *Stepper motor with micro controller and | + | *Stepper motor with micro controller stands stationary on one end and calibration device would be connected to a slide rail system for stability |
| − | |||
| − | [[File: | + | [[File:Gears 01.gif|thumb|Clamping Plate Setup http://www.polytechdesign.com/images/gears_01.gif]] |
Revision as of 22:51, 1 December 2010
Overview
- Create a linear motion device that will calibrate a set array of Scintillators using light pulses
Ideas
- Printer disassembly and take-over of printer head linear motion through use of serial port programming with C
- Worm gear connected to DC motor with micro controller set up
- Linear Rail system
- Belt System
Belt System
- Stepper motor with micro controller stands stationary on one end and calibration device would be connected to a slide rail system for stability
Clamping Plate Setup http://www.polytechdesign.com/images/gears_01.gif
