Difference between revisions of "BW July 2018"
| Line 10: | Line 10: | ||
7/20: On Monday I need to put the bundle 404 tests in the testing logbook. They should go there as well as in my spreadsheet. | 7/20: On Monday I need to put the bundle 404 tests in the testing logbook. They should go there as well as in my spreadsheet. | ||
| + | |||
| + | 7/24: I measured bundle 401 on the popsicle stick. Bundle positions 16 to 30 are 6.81 mm wide including the Kapton. Measuring at positions 1 to 15, the bundle is 12.43 mm wide including the Kapton. The bundle is around 10 mm high, as it should be. | ||
Revision as of 16:56, 24 July 2018
7/13: Yesterday I did some practice fuses and then fused four productions fibers in bundle 404 using a piece of sponge gasket to keep the clamps from bottoming out. The work was slow because it took me a long time to remove wings.
Today Jim said Andrew was getting very good results from fusing. He suggested that Andrew should take over as primary fusing technician. That may be a good idea since Andrew seems to be quicker at removing wings.
While Andrew was learning to fuse scrap fibers with the sponge gasket, I cut more short fibers. Later I cleaned a bundle of shorts scraps and started polishing a new one.
7/18: The piece of sponge gasket for gripping fibers was missing today. I may have lost it while cleaning up the fusing work station today. Andrew made a new one.
7/19: Sci-Fi bundle 6 was left out of the storage box overnight one night this week. We need to avoid repeating this mistake.
7/20: On Monday I need to put the bundle 404 tests in the testing logbook. They should go there as well as in my spreadsheet.
7/24: I measured bundle 401 on the popsicle stick. Bundle positions 16 to 30 are 6.81 mm wide including the Kapton. Measuring at positions 1 to 15, the bundle is 12.43 mm wide including the Kapton. The bundle is around 10 mm high, as it should be.