Microscope Prototype Mechanical Design Drawings

TAGGER MICROSCOPE PROTOTYPE

Purpose

The purpose of this page is to list the pertinent files used during the design and construction of the Prototype for the Tagger Microscope.

Repository

Mechanical Drawings

• Top Plate - Top View of Back-Plane, Amp. Board, & Card Guides (TurboCad v12 / AutoCad 2010)

• Top Plate – Holes & Cut-out (TurboCad v12 / AutoCad 2010)

• Top Plate – Holes to be drilled (TurboCad v12 / AutoCad 2010)

• Top Plate – Cut-Out only (TurboCad v12 / AutoCad 2010)

• Bottom Guard for Amplifier Board (TurboCad v12 / AutoCad 2010)

• Backplane Board (TurboCad v12 / AutoCad 2010)

• Amplifier Board (TurboCad v12 / AutoCad 2010)

• Digital Board (TurboCad v12 / AutoCad 2010)

• Bottom Plate (TurboCad v12 / AutoCad 2010)

• 4x4 mm Pack (TurboCad v12 / AutoCad 2010)

• Prototype Feet (TurboCad v12 / AutoCad 2010)

Data Sheets

---

• Sponge Gasket Data Sheet (PDF)

• Hardware Parts List (Excel)

• Pin-out of Euro Connector Receptacle-48pin (PDF)

• Pin-out of Euro Connector Receptacle-96pin (PDF)

• Pin-out of Euro Connector Right Angle Receptacle-96pin (PDF)

• Mechanical Data Sheets (Folder)

• Scintillating Optical Fibers Brochure (PDF)

• Scintillation Materials and Assemblies Brochure (PDF)

Pictures

---

• Pictures of the Amplifier Board Close-up (Folder)

• Pictures of the Prototype Set-up Prior to Welding (Folder)

• Pictures Non-Welded Frame (Folder)

• Pictures of the Glued Spacer on the Amp Board (Folder)

• Pictures of the Hall-B Beamline (Folder)

• Lowes Trip for Heat Treating Unit (Folder)